Shark SV75 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Aspirateurs Shark SV75. Shark SV75 User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
CHARGING YOUR HAND VACUUM
1 Before first using the hand vacuum, make sure that the On/Off switch is in the “Off”
position and charge until indicator light turns OFF, max. 6 hours.
2 Connect the charging jack to the charging hole that is on the back of the vacuum.
3 Plug the charger into the wall outlet. The charging indicator light will illuminate to show
that the vacuum is being charged.
4 After first use, discharge the unit fully and then recharge until indicator light turns OFF,
max. 6 hours.
MAXIMIZING THE LIFE OF YOUR NI-MH BATTERY
5 Do not store in areas of high temperature or humidity.
6 Use only the charger supplied with the product. If other chargers are used, the
batteries can fail causing damage to the battery, product or personal property.
7 After 3 months of non-use, the product should be fully discharged and then recharged
to maximize battery power.
8 If the product has never been used or has been stored for an extended period of time
without use - it will take several complete charge and discharge cycles to realize the
full operational time of your product.
9 Ni-MH batteries have a long useful life but at some time they will need to be replaced.
To purchase replacement batteries, visit www.sharkclean.com.
ASSEMBLY OF THE HAND VACUUM
IMPORTANT: The dust cup filter must always be used when operating the hand vacuum.
10 Push the dust cup release button and remove the dust cup.
11 Verify that the dust cup filter is inside, then reattach the dust cup to the hand vacuum.
12 The motorized brush can be used to vacuum short pile carpets or rugs. To attach
the motorized brush, make sure the On/Off switch is in the Off position. Then firmly
insert the motorized brush into the air-intake nozzle, ensuring that the contact pins are
engaged in the connector slots of the unit.
WARNING: Do not touch the motorized brush while it is in motion.
13 The crevice tool can be used to clean narrow, hard to reach places. To attach the
crevice tool, push the attachment into the air-intake nozzle.
USING THE CORDLESS VACUUM
CAUTION: The air-intake nozzle and attachments must be free of obstructions at
all times, otherwise the motor will overheat and could become damaged.
14 To start the vacuum, push the “On/Off” switch to the “On” position.
15 To turn the vacuum “Off”, push the “On/Off” switch to the “Off” position.
CHANGING & CLEANING THE DUST CUP FILTER
NOTE: It is recommended that the dust cup filter be replaced every 6 - 9 months to ensure
peak performance of the vacuum.
16 Press the dust cup release button and pull out the dust cup.
17 Carefully remove the dust cup filter and empty the dust from the dust cup.
18 Rinse the dust cup filter in cold water and let it dry completely before replacing back
into the dust cup. Do not wash it in a washing machine or use a hair dryer to dry it.
Air dry only!
BATTERY PACK REPLACEMENT & DISPOSAL
The cordless hand vacuum is powered by Ni-MH batteries, which must be recycled or
disposed of properly in accordance with state, federal and local laws. If uncertain as
to how to remove the battery pack, we suggest that you take your hand vacuum to a
reputable small appliance service technician to have this service performed. Do not
attempt to replace the batteries used in this product with any other type of battery. Follow
these steps when replacement of the battery pack is required:
19 Using a #1 Phillips head screwdriver, remove the single screw securing the battery
compartment cover located underneath the unit.
20 To remove the cover, lift up the battery compartment cover. Never open the battery
compartment except to replace the battery pack. Set the cover and the screw aside.
21 Slide the battery strap over and lift it out.
22 Carefully lift out the top battery pack and disconnect the terminals.
TECHNICAL SPECIFICATIONS: 15.6 Volt MAX** Ni-MH Battery dc
1 Air-Intake Nozzle
2 Dust Cup Container
3 Dust Cup Filter
4 Dust Cup Release Button
5 Charging Indicator Light
6 On/Off Switch
7 Motor Housing
8 Charging Adapter
9 Motorized Brush
10 Crevice Tool
23 Connect the terminals to the new battery and insert into the battery compartment;
taking care to connect the black lead (-) to the negative connector first and the red
lead (+) to the positive connector second and insert into the battery compartment.
Take care to tuck the wiring completely in so that the wiring does not interfere with the
battery compartment cover when it is replaced.
24 Replace the battery strap, the battery compartment cover and the screw making sure
not to over-tighten the screw.
WARNING: Never use ordinary batteries for replacement as these may leak and damage
your vacuum cleaner. Use only the battery pack XB75N provided by EURO-PRO Operating
LLC for replacement. Call customer service at 1 (800) 798-7398 or visit our web site at
www.sharkclean.com to order replacement battery packs.
CAUTION:
Use only with battery pack supplied.
Do not attempt to remove the battery pack from the unit to charge.
Never throw the battery pack or the appliance into a fire or incinerate it.
Do not remove or damage the battery casing.
Do not place the batteries on metal surfaces.
Do not touch metal parts of the batteries together as the batteries will overheat.
TROUBLE SHOOTING
PARTS
To order additional parts for your Shark
®
CORDLESS HAND VACUUM models
SV75_N 14, SV75Z_N 14, SV75SP_N 14 go to www.sharkclean.com
or call 1-800-798-7398.
PART PART NO
Dust Cup Filter XSB726N
Battery Pack XB75N
Charging Stand (optional) 1048FI
Charging Adapter XA75N
FEATURES
The hand
vacuum will not
operate
Motorized brush
will not work
Hand vacuum will
not pick up or
suction is weak
Dust is escaping
from the hand
vacuum
Batteries need to be recharged.
Batteries are dead and need to be replaced.
There is no power in the electrical outlet being used while charging.
Try to charge using a different electrical outlet.
The metal contact pins on the motorized brush are not in contact
with the connector slots on the vacuum. Remove the motorized
brush and re-insert firmly into the air-intake nozzle.
The motorized brush is blocked. Carefully remove all the lint, hair,
etc. from the motorized brush.
Dust cup is full. Empty the dust cup.
Dust cup filter needs cleaning or replacement. Clean or replace the
dust cup filter.
Vacuum needs to be recharged.
Empty the dust cup container.
The dust cup filter is not installed correctly. Remove it and re-insert it.
The dust cup filter has a hole or a puncture in it. Replace it with a
new one.
SAVE THESE INSTRUCTIONS
TWO YEAR LIMITED WARRANTY
EURO-PRO Operating LLC warrants this product to be free from material defects and
workmanship for a period of two (2) years from the date of purchase when utilized for normal
household use, subject to the following conditions, exclusions and exceptions.
The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or
replacement of the unit at our option. This warranty does not cover normal wear of parts and
does not apply to any unit that has been tampered with or used for commercial purposes.
This limited warranty does not cover damage caused by misuse, abuse, negligent handling
or damage due to faulty packaging or mishandling in transit. This warranty does not cover
damage or defects caused by or resulting from damages from shipping or repairs, service or
alteration to the product or any of its parts, which have been performed by a repair person not
authorized by EURO-PRO Operating LLC.
Non-durable parts, including, without limitation, filters, brushes and electrical parts which
normally require replacement are specifically excluded from this warranty.
If your appliance fails to operate properly while in use under normal household conditions
within the warranty period, you may return the complete appliance and accessories with proof
of purchase and date, freight prepaid. For customer service support, call 1-800-798-7398
or visit our web site at www.sharkclean.com.
If the appliance is found by EURO-PRO Operating LLC to be defective, in EURO-PRO Operating
LLC’s sole discretion, we will repair or replace it free of charge. Proof of purchase date and
check made payable to EURO-PRO Operating LLC in the amount of $12.95 to cover the cost
of return shipping and handling must be included.
This warranty is extended to the original purchaser of the unit and excludes all other legal,
implied and/or conventional warranties. The responsibility of EURO-PRO Operating LLC if
any, is limited to the specific obligations expressly assumed by it under the terms of this
Limited Warranty. In no event is EURO-PRO Operating LLC liable for incidental or consequential
damages to anyone of any nature whatsoever. Some states do not permit the exclusion or
limitation of incidental or consequential damages, so the above may not apply to you.
This Limited Warranty gives you specific legal rights, and you may also have other rights which
vary from state to state or province to province.
*IMPORTANT: Carefully pack item to avoid damage in shipping. Be sure to include proof of
purchase date and to attach a tag to item before packing including your name, complete
address and phone number with a note giving purchase information, model number and what
you believe is the problem with the item. We recommend you insure the package (as damage
in shipping is not covered by your warranty). Mark the outside of your package “ATTENTION
CUSTOMER SERVICE”. We are constantly striving to improve our products, therefore the
specifications contained herein are subject to change without notice.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING YOUR CORDLESS HAND VACUUM
When using your hand vacuum, basic safety precautions should always be followed,
including the following:
1. DO NOT use, charge or store the hand vacuum outdoors or on wet surfaces. Store the cordless
vacuum indoors. Put vacuum away after use to prevent accidents.
2. Use only as described in this manual.
3. DO NOT allow to be used as a toy. Close attention is necessary when used by or near children. DO
NOT leave vacuum unattended while in use.
4. DO NOT handle plug, charger or appliance with wet hands.
5. Fully assemble hand vacuum before operating. DO NOT use hand vacuum cleaner without dust cup
filter in place. Use only on dry, indoor surfaces.
6. DO NOT use charger with an extension cord. Plug charger directly into an electrical outlet. Use
charger only in a standard electrical outlet.
7. DO NOT attempt to use the charger with any other product nor attempt to charge this product with
another charger. Use only the charger model ZD6W210024US supplied with this appliance.
8. DO NOT use charger with damaged cord or plug. If charger or hand vacuum has been dropped,
damaged, left outdoors, or dropped in water, return it to EURO-PRO Operating LLC for examination,
repair or adjustment.
9. DO NOT abuse the charger cord, pull cord around sharp edges or corners or close door on cord.
Never carry the charger by the cord or yank to disconnect from an outlet; instead grasp the plug
and pull to disconnect. Keep charger cord away from heated surfaces.
10. Use only manufacturer’s recommended attachments. Always turn off this appliance before
connecting or disconnecting the motorized nozzle. DO NOT attempt to change accessories while
unit is running.
11. Use extra care when cleaning on stairs.
12. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
13. DO NOT put any objects into openings. DO NOT use with any opening blocked; keep free of dust,
lint, hair and anything that may reduce air flow.
14. DO NOT use to pick up flammable or combustible liquids such as gasoline or use in areas where
they may be present. DO NOT pick up anything that is burning or smoking, such as cigarettes,
matches, or hot ashes.
15. This product includes rechargeable Nickel Metal Hydride batteries. Batteries must be recycled
or disposed of properly and safely. The battery must be removed from the appliance before it is
discarded. The appliance must be disconnected from the supply when removing the battery. Do
not incinerate batteries or expose to high temperatures, as they may explode.
16. DO NOT charge the battery at temperature below 32°F (0°C). This will degrade the battery
performance, shorten life and cause gas leakage from venting. Optimum charging efficiancy for the
battery is within temperature range of 50°F (10°C) and 86°F (30°C).
17 DO NOT charge with the battery polarity reversed. This will cause battery venting, swelling or
rupture.
18. Leaks from battery cells can occur under extreme conditions. Improper use of the battery can
cause the safety vent to activate. Small amounts of liquid (alkaline electrolyte) will leak from the
vent near the terminal. If the liquid gets on the skin, wash immediately with soap and water. If the
liquid gets into the eyes, flush them immediately with clean water for a minimum of 10 minutes
and seek medical attention.
19. DO NOT use for any purpose other than described in this user’s guide. Look on your hand vacuum
and follow all label and marking instructions.
20. This vacuum is intended for household use only.
21. DO NOT charge the unit outdoors.
Ni-MH BATTERY MUST BE
RECYCLED OR DISPOSED
OF PROPERLY
1
2
3
5
6
9
8
4
7
10
SV75_N 14
SV75Z_N 14
SV75SP_N 14
IMPORTANT: To register your Shark
®
Cordless Hand Vacuum,
visit our website www.sharkclean.com.
SV75_N series.ES.130715_1
Copyright © EURO-PRO Operating LLC, 2013
Boston, MA 02459 / Ville St. Laurent, Québec H4S 1A7
1-800-798-7398
www.sharkclean.com
Printed in China
Illustrations may differ with actual product.
**Maximum initial battery voltage
Vue de la page 0
1 2

Résumé du contenu

Page 1 - SV75SP_N 14

CHARGING YOUR HAND VACUUM1 Before first using the hand vacuum, make sure that the On/Off switch is in the “Off” position and charge until indicator l

Page 2

CARGA DE SU ASPIRADORA DE MANO1 Antes de usar la aspiradora de mano por primera vez, verifique que la llave de encendido esté en la posición “Off” y

Commentaires sur ces manuels

Pas de commentaire