Shark 50 Manuel d'utilisateur télécharger pdf (Page 7)

Ok, now we're stabilized, hovering at around 50m, all's fine. We can see the steerpoint carat on the HUD which

will lead us towards waypoint 1, and the HUD also displays altitude, heading and speed. Since we're in hover

mode the hover point reference circle is also displayed on the HUD, it's basically a top-down view with the

little square depicting the hover point, which helps maintaining a position during hover. And in the corner of the

HIS we see that we're just 6km from our 1st waypoint. Use the rudder to place the steerpoint carat right onto the

little inverted triangle, which is the current heading marker. Now, let's switch off auto-hover, press the trim

button, lower the nose by moving the cyclic controls forward and increase collective so that we don't lose

altitude. Once the nose is ~10°down we can release the trim button and should be picking up speed. And raise

the gear ("g")

Try to stabilize the aircraft at 50m altitude, 150 km/h.

After we've reached WP1 select WP2 by clicking on the corresponding number on the PVI 800. You should

notice the steerpoint carat move, change course to put it on the heading marker again.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Pas de commentaire

Shark 50 Manuel d'utilisateur Page 7